TMQ AP55 Display Head, Operation And Installation

Page: 19 / 33

TMQ AP55 Display Head Page 19 Ver1.0 08/12/2005
The number on the display will be between 0 and 31 to indicate the
rudder position. “SL31” being fully to Starboard and “PL31” being fully
to port.
If “ oor” (Out of range) is displayed it indicates the rudder is not in the
correct position to set the rudder limit. I.e.
Rudder is to port when
setting the Starboard limit.
If at any time during testing the motor runs under load and the rudder
does not move, checks should be carried out to confirm the limit
switches are operating prior to the rudder running into the stops.
Reset Rudder Limits
It is possible to reset the rudder limits to the factory settings if unsure of
the settings.
Press the MODE Button 7 Times
“ rLr” will Display (Reset Limit Rudder).
Press < > both simultaneously to reset rudder limit.
Compass Calibration
The AP55 Display Head will enable you to complete a compass
calibration. If you have a steel vessel, or some other factor, which causes
the compass to perform poorly, the calibration procedure will adjust
compass characteristics to compensate.