Before You Start
Please read these instructions completely and carefully:
This is a safety
alert. Always read
and obey all safety
messages. This
symbol warns you of
potential hazards
that can kill or hurt
you and others.
L
This is an
information symbol.
Indicates additional
detailed instructions
are given in this
manual.
You can be seriously
injured if you don’t
follow the instructions
in this manual before
you start.
WARNING
CAUTION: Oven is heavy. Use care in handling.
9
Proper Installation
is your responsibility.
Ensure the oven is electrically connected by a
qualified electrical installer and conforms with the
National Electrical Code, ANSI/NFPA 70 – latest
edition, or in CANADA, Canadian Electrical Code,
CSA C22.1-1982 and C22.2 No. 01982 – latest
edition.
Ensure this oven is properly grounded.
L
See “Electrical Requirements”
&
“Installation
Steps, Making the Electrical Connection” for details.
Potential fire or burn hazard
exists if cabinets
above the oven are used for storage.
9
Electrical Preparation:
a 1” diameter hole (or
larger) should be drilled in the top left rear corner of
the oven cabinet and/or sheet rock to enable the
4-wire oven electrical cord to pass through the
cabinet to connect to the household electrical
supply.
L
See “Cabinet Dimensions” for details
.
Quick Reference:
Required cabinet cutout width of 28 1/2”
(72.4 cm) minimum - 28 3/4” (73 cm)
maximum
is needed.
9
Do not use this appliance for space heating.
Required cabinet cutout depth of 24” (61 cm)
is needed.
9
9
We HIGHLY RECOMMEND running CAT5 cable
to where the back of the oven will be located.
9
Oven support surface
should be flat, level and
be able to support a weight greater than 575
pounds (261 kg).
9
All governing codes and ordinances
must be
observed.
9
Do not remove permanently affixed labels,
warnings, or plates from the oven! These are
important for your safety.
9
Recessed installation area
must provide
complete enclosure around the recessed portion
of the oven.
9
Always disconnect the electrical supply to the
oven before servicing.
9
Oven location
should be away from strong draft
areas (windows/doors) and strong heating vents.
Tools Needed:
Phillips screwdriver
Parts Supplied:
8 mounting screws
1
