W W W . T M G I N D U S T R I A L . C O M P 1 6 / 1 7 To l l F r e e : 1 - 8 7 7 - 7 6 1 - 2 8 1 9
Figure 13
Step 9 : Tension the cover on the frame from side to side (figure 14)
After the cover is installed on the roof, insert the plastic pipe (#37) slowly into
the grooves on two ends of the cover (not two sides), and then insert tension
tubes (#14) in the groove on both sides of the cover bottom, Add the water
plug (#25) on the 1st tube (#14) to protect the fabric while the tube is going
through and add the water plug on the last tube also to keep water away.
Stretch and adjust the cover from left and right, back and forth, to make sure it
is square and centered. Cut the grooves from inner side facing to the ratchet
hardware (#7A), and add tie down straps (#21) to pull the tension tube and tie
the strap to the base.
Evenly adjust the ratchets on both sides of the cover to take wrinkles out and
make the cover flat and smooth. Do not fully tie the cover yet. Leave adequate
strap so that the cover can also be adjusted front to back in next step.
Parts used in this step.
-
(50) Ratchets (#7A)
-
(2) Top cover tension tube (#14)
-
(50) Tie down straps (#21)
-
(28) Tube clamps (#21A)
-
(4) Tension tube end water plug (#25)
-
(28) Hex bolt (#27)
-
(10) Plastic hose (#37)
-
(8) Connector (#37A)
