W W W . T M G I N D U S T R I A L . C O M P 1 7 / 2 0 To l l F r e e : 1 - 8 7 7 - 7 6 1 - 2 8 1 9
Pull cable (#B) from the winch to run through the lower roller of the dual
pulley (#23C), go straight down at the left side, reach to the left end of
dropping tube (#15). Tie the cable to the end hole.
Connect cable( #23A) to the winch and pull it to run through the upper
roller of the dual pulley (#23B), reach through the single pulley( #23C),
then go straight down to the right end of dropping tube (#16). Tie the cable
to the end hole.
Now the door can be opened or closed by operating the winch assembly.
Run the door up and down a few times to make sure all dropping tubes are
moving smooth. Use lubricant oil if needed.
Parts used in this step.
-
(7) Front roll up door dropping tubes (#15)
-
(7) Front roll up door dropping tubes (#16)
-
(1) Roll up door hand winch (#23)
-
(1) Wire rope for front and rear door hand winch (#23A)
-
(2) Hex bolt (#31)
-
(1) Braided rope (#32)
-
(1) Front roll up door cover panel (#35)
-
(1) Front fabric tarp secure pin (#36)
