Wireless NVR Kit Manual
7
3. Installation and connection
3.1 Installation Notice
Note the following when installing:
1, In order to extend the life of the machine, the device should be away from water, high temperature, dust
environment, and placed in a well ventilated place.
2, Please use the SATA hard drive, USB device, mouse device buying from proper channels.
3, Before use, please ensure that the network high-definition video recorder grounded correctly, the power
supply can not exceed the power supply normal operating voltage range.
3.2 Preparation before installation
1, Determine the installation location of the NVR
It is recommended that the NVR be placed in the center of the monitoring area, and the installation
position of the IPC (wireless camera) and NVR should avoid the obstacle as much as possible. When the
4-channel video are connected at the same time and there is no obstacle between the NVR and the IPC,
the IPC is placed in a spherical coverage area with a radius of 60 m with NVR as a center of gravity. The
radius is reduced to 30 meters when there are one wall between the NVR and the ipc. When there are two
walls, it reduced to 15 meters radius (coverage affected by the physical properties of the obstacles and the
surrounding environment, this data is for reference only)
1, Connection steps
1
、
Connecting the NVR with the mouse and the display firstly, turn on the power of the NVR and the IPC,
then connect the NVR to the IPC with the cable. Right click on the mouse -> click on adding camera->
delete all channels (Note: if only delete some bad channels, can click to delete the channel to delete the
specified channel) -> code matching -> "start code matching?" Click Yes -> Show "on the code matching" ->
NVR monitor screen shows that the success of the code matching(note: More than one camera can make
code matching at the same time). If notify the code matching fails, click "Refresh". If there is no indication
that any network cable is bad, please re-connect to the code matching operation. -> disconnect the network
cable to see if the screen is normal, the screen normal means that the wireless camera add successfully ->
when all the wireless camera added to the NVR means that the preparatory work is completed. (Figure 5.1,
Figure 5.2, Figure 5.3, Figure 5.4)
2
、
Make sure the wireless NVR kit is working properly
NVR connection monitor, all the IPC installed around the NVR (Note: need to connect the antenna),
