ENGLISH
ENGLISH
ENGLISH
65
Remount the cover, being careful to the O-Ring and to insert the filter
cover nose correctly into the hole of the filter cartridge. Greasing the O-
Ring with a small amount of grease helps to keep it in its seat when
assembling.
Tighten the screws at 10Nm.
REMEMBER THAT THE FILTER CARTRIDGE CANNOT BE CLEANED,
IT MUST BE REPLACED AT THE ENVISIONED INTERVALS.
Prepare a measuring beaker with 1.4 (1.0 for 660 SMX) Litres of fully
synthetic engine oil of the established type (see engine data). Unscrew
the oil load cap and fill with about 0.8 Litres.
Close the cap temporarily, start-up the engine and allow it to run for
about 5 seconds. DO NOT ALLOW IT TO RUN LONGER TO PREVENT
DAMAGE.
Re-open the cap and finish filling with the oil remaining in the measuring
beaker.
A total of 1.4 (1.0 for 660 SMX) Litres of oil has been introduced.
Tighten the cap at 20Nm.
Start the engine and check tightness of the filling and emptying caps,
the net filter cap and the filter cartridge cover.
Finally, check the engine oil level and correct it if necessary.
FRAME AND ENGINE MAINTENANCE
FRAME AND ENGINE MAINTENANCE
FRAME AND ENGINE MAINTENANCE
FRAME AND ENGINE MAINTENANCE
FRAME AND ENGINE MAINTENANCE
FRAME AND ENGINE MAINTENANCE
FRAME AND ENGINE MAINTENANCE
FRAME AND ENGINE MAINTENANCE
FRAME AND ENGINE MAINTENANCE
FRAME AND ENGINE MAINTENANCE
Summary of Contents for 2008 4 Stroke
