172-65411MA-05 (PT1) 5 Jun 2019
23
12. Settings
This section explains how to adjust PT1 settings. Default settings are already set in
advance when shipped from the factory, but can be adjusted anytime to meet the
needs of the user. Settings are saved in memory, and are maintained after the power
is turned off.
12.1 Access Setting Selection
1) With the power on, simultaneously press [
]
[ENT].
2) Perform the following actions for each setting:
a) Press [
] or [
] to highlight the desired mode or setting. (Slightly different
operation when
setting “12.5 Earphone Volume” and “12.8 LCD Contrast”.)
b) Press [ENT] to select highlighted mode and proceed to next setting option.
c) Press and hold [ENT] for more than 1 second to exit settings and return to
normal operation.
12.2 Mode Selection
Set the mode to the type of inspection to be performed.
Trap&Valve
: To perform steam trap or valve diagnosis.
Bearing
: To perform a bearing inspection.
12.3 View Mode Selection
Select what data is to be shown when performing a bearing inspection.
Note: View mode only affects
the display in “Bearing” mode.
Full Mode
: Display all measurement data.
AVG & Temp.
: The average acceleration level (AVG) and
the surface temperature are displayed in large font (PEAK
and CF values are not shown).
Peak & CF
: The PEAK (highest measured acceleration) and
CF (Crest Factor) values are shown (AVG value and
temperature are not shown).
See Section 10.5 for display samples and explanations.
12.4 Backlight
Turn the backlight on or off.
Note: The operating the PT1 with the backlight on consumes
more power, shortening the lifespan of the batteries.
Mode
Trap&Valve
Bearing
View Mode
Full Mode
AVG & Temp.
Peak & CF
Back Light
On
Off
