172-65411MA-05 (PT1) 5 Jun 2019
15
8.7 Retake Measurement and Proceed to Next Measurement
1) If the measurement or judgement is in doubt and you wish to verify by measuring
again, simply apply the probe to the measurement point again (see 8.3). The
measurement will restart automatically.
Note: The second measurement will overwrite the data from the first measurement;
the original data will be lost.
2) If the measurement and judgement are acceptable, proceed to next device.
a) Press [ENT] to save data. (
“Check Inlet” will be displayed.)
3)
If the next device to inspect is a steam trap, repeat operation from “8.2 Set Record
Number”.
4) If the next device to inspect is a valve, switch PT1 diagnostic modes.
a) Press [
]
[
] simultaneously, changing mode to “Valve”.
b)
Follow the instructions under section “9. Valve Diagnosis”.
5) If finished performing inspections, turn PT1 off.
a) Press and hold [ENT] for more than 2 seconds.
