172-65411MA-05 (PT1) 5 Jun 2019
21
10.6 Proceed to Next Measurement
1) If the measurement or judgement is in doubt, or if you wish take the average of
multiple measurements (for a longer operation time analysis), proceed as follows:
a) Press [
] / [
] to set the data number. The data number is a single digit
number from 1 to 9.
b) If any data is recorded at the selected data number, its contents are shown.
Note: If data is already recorded at the selected data number, taking a
measurement will overwrite the data.
c) Once the data number is selected, press the probe against the measurement
point to begin. Proceed to “10.4 Take Measurement”.
2) If the measurement data is acceptable, save the data.
a) Press [ENT] to save the data in the present record and return to the original screen.
b) When only one measurement was taken, its results will be saved and shown. If
multiple measurements were taken, the average of all measurements will be saved
and shown (data from individual measurements (Data No.) will be discarded).
3) If another bearing requires inspection, repeat operation from
“10.3. Set Record Number”.
4) If finished performing inspections, turn PT1 off.
a) Press and hold [ENT] for more than 2 seconds.