NOTE:
Failure to follow these mounting instructions may lead to a DSF2 that will not stay in position and could possibly lead to
a dangerous mounting condition. After the mounting bracket has been installed firmly in place, the DSF2 can be secured to the
mounting bracket. Make sure to consider the routing of the power cord before mounting the DSF2 to insure the cord is routed
away from the fan’s moving parts and pivot points. Make sure to place one of the provided lock washers over each of the side
mounting studs before securing the DSF2 to the mounting bracket. Once the unit studs are inserted through the mounting bracket,
install the tooth nut to the studs with the teeth of the nut facing the bracket. The images below show the order of the hardware
before and after it is installed.
Once the fan is secured to the Mounting Bracket, tighten the (2) nuts with a 9/16" wrench or until the nuts apply tension to the
bracket. Pivot the DSF2 to the final mounting angle desired. Finish tightening the (2) nuts firmly to insure the fan does not move
during operation.
SAFETY CABLE INSTALLATION
The provided safety cable is purchased from a certified 3rd party. Follow the cable provider’s installation instructions. The following
images are to serve as aide to those instructions.
ACCESSORIES
Optional Equipment:
DSF2FG - Fan Guard Kit Shields fan blades from incidental contact.
Optional Controls:
DSF2TR - Multi-Voltage Transformer converts all typical ceiling level power sources to 120 VAC.
(Single Phase 208,220,230,240,277 & 480 Volt)
950-8415 - 120 Volt Wall Mount Speed Control Rated for use with up to 20 DSF2 fans.
3
Tooth Nut, Mounting Bracket, Lock Washer, Stud
Mounting Hardware Shown Assembled.
Lock Washer
Bracket
Nut
Lock Washer
Bracket
Nut
Loop safety cable around
solid anchor point.
Feed cable with clamp
through DSF2 holes
.
Feed cable end through
clamp as instructed.
Feed cable back through
clamp with
minimum
6" tail.
TJERNLUND LIMITED ONE YEAR WARRANTY
Tjernlund Products, Inc. warrants to the original purchaser of this product that the product will be free from defects due to faulty material or workmanship for a period of (1)
year from the date of original purchase or delivery to the original purchaser, whichever is earlier. Remedies under this warranty are limited to repairing or replacing, at our
option, any product which shall, within the above stated warranty period, be returned to Tjernlund Products, Inc. at the address listed below, postage prepaid. THERE ARE
NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF, AND TJERNLUND PRODUCTS, INC. EXPRESSLY DISCLAIMS LIABILITY
FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM THE USE OF THIS PRODUCT. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WAR-
RANTIES AND NO AGENT IS AUTHORIZED TO ASSUME FOR US ANY LIABILITY ADDITIONAL TO THOSE SET FORTH IN THIS LIMITED WARRANTY. IMPLIED
WARRANTIES ARE LIMITED TO THE STATED DURATION OF THIS LIMITED WARRANTY. Some states do not allow limitation on how long an implied warranty lasts,
so that limitation may not apply to you. In addition, some states do not allow the exclusion or limitation of incidental or consequential damages, so that above limitation or
exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights which may vary from State to State. Send all inquiries
regarding warranty work to Tjernlund Products, Inc. 1601 9th Street, White Bear Lake, MN 55110-6794. Phone (651) 426-2993 • (800) 255-4208 • Fax (651) 426-9547 •
Email [email protected].
