8 – ENGLISH
a confirmation beep will sound. The EQ will remain off until “EQ On” is selected. The EQ differs from Audio
in that it enhances lower frequencies primarily at lower volume levels. We suggest the rear Bass level be set
to the center detent position. Should the bass ever sound distorted, immediately lower the bass level and/or
volume. For more, see the section marked “Getting the most from your Music System BT.”
14.
DISPLAY:
When in FM mode, briefly press repeatedly to select between RDS Scrolling Text, (Figure 11), Static
Text, or RDS Off. If a station is not broadcasting in RDS or the RDS signal is too weak, no RDS text will be
shown. In cases where the signal is weakly received the text may be scrambled. Note the AM band does not
utilize RDS text. For more, see “Reception/RDS”. RDS text will not be shown in Sleep mode. When playing a
CD, press repeatedly to select between CD Scrolling Text, Static Text, or CD Text Off. If the inserted CD does
not contain CD text (Figure 12), then this feature cannot be enabled. Not all commercial music CDs contain
CD Text. CD text will not be shown in Sleep mode.
15.
SNOOZE/MUTE (Top of Cabinet):
When the Alarm activates, press this button to silence the alarm for 7
minutes. The display will count down the remaining Snooze time. Adjusting the volume level will cancel the
Snooze mode. During normal operation, press this button to mute the audio. The display will show “Muted”.
Press again to restore the audio output or adjust the volume level.
16.
HEADPHONE OUT:
Connect a set of headphones (not included) to this variable stereo output for private listening.
Plugging in the headphones will mute the primary speakers. The headphone’s volume is adjusted using the front
panel volume knob. This stereo output accepts a 3.5 mm stereo male mini connector. Avoid using headphones at
high volume levels to prevent possible hearing damage.
17.
IR SENSOR:
Receives signals from the included remote control. Do not obstruct this sensor.
18.
SLOT-LOAD:
Insert a disc (with printing side facing up) until it is drawn inside. The display will say “Load-
ing”. Disc functions will not work while the disc is loading. Playback will begin automatically once the table of
contents is read. The display will show “No Disc” when the unit is set to CD mode and there is no CD inside.
When ejecting a CD the display will show “Ejecting”. For more, see “Important Notes About the CD Player.”
Fig 11, 12
Summary of Contents for ONE BT
Page 58: ...58 ESPAÑOL ...
Page 89: ...89 ITALIANO ...