www.tivolilighting.com tel: 714-957-6101 fax: 714-427-3458
Copyright © 2021 Tivoli 11.24.2021
7170805
Page 2 of 11
FLEX120
| Installation
PLEASE VERIFY THE CONTENTS OF THE PACKAGES!
PLEASE READ INSTRUCTIONS ENTIRELY BEFORE
STARTING INSTALLATION.
BE SURE POWER IS TURNED OFF BEFORE
INSTALLING OR MODIFYING THE SYSTEM.
CALL TIVOLI LLC TECH SUPPORT WITH QUESTIONS.
Caution:
FLEX120 is designed to work with 120V AC power
supply only. Use of any other power source will cause
damage, shorten the life of the fixture and will void the
warranty.
Note:
Use in clean, smooth, surface applications.
Attaching to textured surfaces without the use of a
mounting channel is not recommended.
Consult any and all applicable local and national codes
for installation.
Do not conceal or extend exposed conductors through
a building wall as per local electrical code.
Warning:
With any luminaire for any application, basic
safety precautions should always be followed to reduce
the risk of fire, electric shock and personal injuries.
This lighting system should be installed by a certified
professional.
Note:
Contacting hot wires against the FLEX120 leads may
damage the product and void the warranty.
Note:
Outdoor FLEX120 is shipped manufactured to
specific lengths with factory attached end preps. It is not
designed to be trimmed in the field.
Refer to NEC and local code requirements. Voltage drop
calculations are the responsibility of the installer.
CAUTION - Risk of Damage. Handle carefully.
1. Do not twist, bend, fold or crease FLEX120.
2. Do not bend or crease lead wire at solder point.
3. Do not attempt to remove FLEX120 once it has been
installed. Attempting to pull FLEX120 away from mounting
surface after it has been adhered will cause damage to the
product.
4. Do not use chemical solvents on FLEX120 during routine
maintenance.
5. Do not cover this product as the covering may cause the
light to overheat and melt or ignite.
6. Do not operate with the FLEX120 tightly coiled. To prevent
overheating do not allow contact between FLEX120 light
cables and part of light cables. Maintain at least 0.47
inches spacing between FLEX120 light cables or parts of
light cables.
7. Do not puncture, cut, shorten, or splice FLEX120
8. Do not route the cord or FLEX120 through walls, doors,
windows or any like part of the building structure.
9. Do not use if there is any damage to the light or cord
insulation. Inspect periodically.
10. Do not submerge FLEX120 in liquids, or use the product
in the vicinity of standing water or other liquids.
11. Secure this FLEX120 using only the screws provided. Do
not secure this product or its cord with staples, nails, or
like means that may damage the insulation or permanently
attach to the building structure.
12. Do not bend FLEX120 continuously.
13. DO NOT EXCEED THE MAXIMUM NUMBER OF
EXTENSIONS OR FLEX120 LENGTHS PERMITTED BY THE
MARKING,
Failure to comply will damage the product and void the
warranty.
Summary of Contents for FLEX120
Page 1: ...IP65 FLEX120...
