OPERATIONS INSTRUCTIONS
1. ON/OFF SWITCH
Switching On and Off
To
start
the machine, push the On/Off switch
forward so that the “
I
” is indicated on the switch.
To
switch off
the machine, push the On/Off
switch toward the rear so that the “
0
” is indicated
on the switch.
Warning
: Be sure that the switch is on the 0
position when you insert the battery in the tool otherwise
the machine will not operate and the LED light starts
flashing.
2. USING THE LED WORK LIGHT
The LED work light allows you to keep a clear view under
less illuminated circumstances. To turn on the light simply
press the on/off switch. When you release the on/off switch,
the light will be off.
WARNING:
The light is a focussed beam and
should never be pointed directly into the eyes of
people or animal.
Note:
When the LED light starts flashing, it means that the
tool needs to be recharged. Proceed as instructed on
previous page.
4. To install the sanding pad:
Align holes in sanding pad with locating pins on accessory
holder (Fig.9)
Securely tighten with the hex key (Fig.10)
The sanding pad is fitted with hook&loop backing for quick
and easy fastening of sanding sheets with hook&loop
adhesion. Position the sanding sheet flush alongside one
edge of the sanding pad and then lay the sanding sheet
onto the sanding pad and press firmly (Fig.11)
5.ADAPTER
Black & Decker blades
can be fitted onto the tool by using
the adapter. (Fig. 12)
1) Use the hex key (5) to unscrew the bolt & flange and then
remove it from the tool holder
2)Clean the tool holder, the adapter and the Black & Decker blade.
3)Fit the adapter onto the tool holder, then place the blade
onto the adaptor. Make sure that the tool holder,the adaptor,
and the blade were assembled together.
4) Tighten with the hex key.
Fig. 12
Fig. 11
Fig. 10
Fig. 9
10.8V MULTI-CUTTER TTP448HTL