TTB892MLT
Getting
started...
EN
23
Before you start
Removing/Replacing (sanding paper)
With the hook-and-loop system, sanding papers are simply removed by pulling off.
> Grip one corner of the sanding paper (11) and pull it off the base plate (7)
(Fig. 2).
> Attach a new sanding paper as required.
Fig. 2
NOTE:
Always remove dust and chips from the sanding base plate
(7) before attaching sanding paper (11) to reduce the wear of sanding
base plate and sanding paper.
If one corner and/or edge of the sanding paper (11) is worn, it can be
re-attached by turning 120º to use the next corner and/or edge.
Adjusting (sanding base plate)
NOTE:
Adjust the sanding base plate (7) at the desired angle according
to the intended use. The tool holder (6) and sanding base plate are
intervals around the tool holder, from 0° to 360°.
If one corner and/or edge is worn, the sanding base plate (7) can be
turned to use the next corner and/or edge.
> Open the SDS tool holder (6) by
opening the SDS clamping lever (1)
fully (Fig. 3, step 1).
> Disengage and adjust the sanding
base plate (7) to the desired position
(Fig. 3, step 2). Make sure the pins of
grooves on the back of the sanding
base plate (7).
> Fix the sanding base plate (7) by
closing the SDS clamping lever (1)
fully (Fig. 3, step 3).
> Check if the sanding base plate (7) is
reliably clamped and make adjustment
if necessary.
Fig. 3
1.
2.
2.
1.
3.
