ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR JIGSAW
1. Always use eye glasses and dust mask.
2. Hearing protection should be worn when using jigsaw.
3. Do not use damaged or worn blades.
4. Always use jigsaw with guard cover down.
5. Regularly check the two screws in the blade clip.
6. Regularly check the adjustment of the support roller.
7. Do not run the machine with any part of the casing missing or damaged.
8. If blade is jammed in work piece ,do not start the jigsaw.
Warning instruction for laser batteries
1. Keep small batteries out of the reach of young children.
2. If battery leakage occurs and comes in contact with the skin or eyes wash immediately
with lots of water.
3. Seek medical advice immediately if you believe a cell has been swallowed.
4. Follow fitting equipment instructions carefully and always use the recommended
type of batteries.
5. Do not allow children to fit batteries with out adult supervision.
6. Ensure that the batteries are fitted the right way round observing and signs on the
battery and the product.
7. Replace all batteries at the same time. Do not mix new and old batteries or batteries
of different types.
8. Ensure the battery compartment lid is securely replaced.
9. Store batteries away from metal objects. Never short-circuit batteries.
10. Remove batteries if equipment is not going to be used for extended periods of
time.
11. Store batteries in a cool, dry place away from direct sunlight.
12. Remove exhausted batteries promptly and dispose of in household waste.
13. Do not put batteries in fire.
14. Do not attempt to revive batteries by heating, charging or other means.
SAFETY POINTS FOR YOUR LASER
The laser device fitted to this tool is class 1 with a maximum radiation
of 1mW and 650nm wavelength. These lasers do not normally present
an optical hazard although staring at the beam may cause flash blindness. Do
not stare directly at the laser beam. A hazard may exist if you deliberately
stare into the beam, please observe all safety rules as follows:
1. The laser shall be used and maintained in accordance with the manufacturer’s
instructions.
2. Never aim the beam at any person or an object other than the work
piece.
3. The laser beam shall not be deliberately aimed at another person and shall
be prevented from being directed towards the eye of a person for longer than
0.25 seconds.
4. Always ensure the laser beam is aimed at a sturdy work piece without
reflective surfaces, e.g wood or rough coated surfaces are acceptable.
Bright shiny reflective sheet steel or similar is not suitable for laser applications as the
reflective surface may direct the laser beam back at the operator.
5. Do not change the laser device with a different type.
Repairs must be carried
SF800XPL SJ800XPL-M-060525.indd 6
2006-5-26 18:34:40
