OPERATION INSTRUCTIONS
Warning: Before using your electric
Pendulum Jigsaw be sure to read the
instruction manual carefully.
1. Fitting the Saw Blade
(See fig2)
Note: When changing blades, set pendulum
action switch to “0”.
The pendulum Jigsaw is equipped with a toolfree
blade holder which can only use with the bayonet
type blade (Fig2A). To open the blade holder,
rotate the ring anti-clockwise (jigsaw upside
down) and hold in position. Then fully insert the
blade into the blade holder slot with blade teeth
facing forward and release the ring, which will self
rotate and clamp over the top of the blade. Push
the blade into the blade holder again to ensure it
is locked in position. Ensure the edge of the blade
is located in the groove of the support roller. To
remove blade, hold the blade and rotate the ring
anti-clockwise then lift out the blade.
Warning:
- Blade teeth are very sharp.
- Blade self-eject out swiftly. Do not point at
people.
- Blade will be spring ejected so protect your
eyes.
- For best cutting result , ensure you use a blade
suited to the material and cut quality you need.
2. Assembly clear blade guard
Remove the clear blade guard by pinching
the clear blade guard slightly and then slide
downward, pull out the guard, fit the blade as
below instruction. (See fig3)
To replace the clear blade guard, pinch the clear
guard, press inwards from bottom of wireframe
safety guard, (See fig4). Slide upward until it
reach the top.
Fig 2
Fig 3
Fig 4
Fig 2A
SF800XPL SJ800XPL-M-060525.indd 10
2006-5-26 18:34:44
