Titan 3515, Operation And Parts Manual

Page: 27 / 78

Titan Implement, LLC 27 3515 Flex-Wing Rotary Cutter
(423) 334-0012 February 2020
16. Apply grease to the zerks on the U-joint crosses.
17. For the 29” Aircraft Tires, ensure the cutter height
adjustment cyilnder is pinned in the top hole (1)
of the cutter deck and ensure the spindles for
each tire are bolted in the innermost hole on the
tailwheel axis. For all the other tire configurations,
ensure the cutter height adjustment cylinder is
pinned in the bottom hole (2) of the cutter deck
and the spindles for each tire are bolted in the
outermost hole on the tailwheel axles.
5.3 Final Assembly and Leveling
Attach the rotary cutter to the tractor. Follow the
procedure in “6.3 Attaching to Tractor” on page 33.
Note: Quick disconnect hydraulic couplers are not
supplied with the unit. If desired, these may be
procured from a local equipment dealer.
5.3.1 Leveling the Center Deck
1. With the cutter attached to the tractor, disengage
the PTO and park on a level, hard surface. Place
the tractor gear selector in park or set the parking
brake.
2. Cycle the wheel lift cylinder several times to purge
any trapped air and charge the hydraulic cylinder.
N O TIC E
The lift cylinder must not be bottomed out during this
procedure, or the leveling rods may become bent.
3. Use the hydraulics to adjust the cutter height until
the front of the skid shoes are two to three inches off
the ground.
4. Adjust the nuts to have equal amounts of tension.
5. Remove the bolt and nut from the lower end of both
tailwheel tubes.