10
FIGURE 6:
Installing Discharge Chute, Snow Spray Mask, and Fittings assembly
a.
Install the Discharge chute and Snow spray mask with hinge rod.
b.
Install 2pcs of plain washer 10 and cotter pins onto both side of the hinge rod.
c.
Install the adjusting plate as discharge angle required, then put the flat washer 10 onto the pin
shaft. Finally secure with the R pin.
d.
Install above components onto the snow blower as
Figure7
.
FIGURE 7:
Discharge Chute Assembly, Snow Spray Mask, and Fittings assembly
Note: The support ring must be located in the roller groove.
Support
ring
Summary of Contents for 170311
Page 5: ...5...
