11
WARNING: DO NOT PERFORM ANY MAINTENANCE OR INSTALLATION
OF ANY COMPONENTS WITHOUT FIRST ENSURING THAT ELECTRICAL POWER
HAS BEEN DISCONNECTED AT THE SOURCE OR PANEL AND CANNOT BE RE-
ENERGIZED UNTIL ALL MAINTENANCE AND/OR INSTALLATION PROCEDURES
ARE COMPLETED.
DANGER: DO NOT RUN POWER UNIT WITHOUT FLUID. DAMAGE TO PUMP
CAN OCCUR. THE POWER UNIT MUST BE KEPT DRY. DAMAGE TO POWER UNIT
CAUSED BY WATER OR OTHER LIQUIDS SUCH AS DETERGENTS, ACID ETC., IS
NOT COVERED UNDER WARRANTY.
16) Install the lifting arms and arm restraint pins. The arm restraint pins must be installed
from the bottom of the mount. This will require removal of the handle, nut, lock washer,
flat washer, and gear block.
17) Adjust the arm lock gear and the arm lock until they mesh, then tighten the nut of the
arm lock.
18) Grease the (4) inside corners of each column to prevent premature wear of the nylon
slide blocks and also to ensure smooth operation of the lift.
19) Fill power unit reservoir with (10)quarts of premium quality ISO-32, AW-32, or AW-46
hydraulic oil only. Be sure to periodically check dipstick to prevent spillage.
NOTE:
This is
a good time to check if all fittings on the lift are tightened properly.
20) Press and hold power button on motor to operate lift. Raise carriages all the way to the
top of the lift, then lower carriages down to the ground to bleed air from the hydraulic
system prior to adjusting cable tension.
NOTE:
Cables must be adjusted so that the
safety locks engage simultaneously prior to lifting any weight.
Use 5/8” wrench to
tighten the nut.
Lock the nut.
Arm lock
Arm lock gear
Summary of Contents for HD2P-9KCL
