19
1.
With driveline attached only to the implement, remove outer driveline (tractor end) from
inner driveline to separate the two profiles.
2.
Park tractor and implement on a level surface.
3.
Raise implement until gearbox input shaft is level with tractor power take-off shaft.
Securely block implement at this height to keep until from lowering.
4.
Shut tractor down without removing support blocks. See
“
Tractor
Shutdown
Procedure
”
on page 26.
5.
Attach outer driveline to the
tractor’s
power take-off shaft. Refer to steps 5-8 under
“
Driveline Hook-Up
”
on page 17.
6.
Hold inner and outer drivelines parallel to each other, or as close to parallel as possible. If
dimension
“A”
is greater than or equal to
1”,
then skip to
“Reassemble
Driveline”
on page 20.
Otherwise continue with step 7.
a)
Measure from end of inner shield
to scribed mark (“X” dimension)
and record.
b)
Cutter off inner shield at the
mark. Cut same amount off the
inner shaft (“X1” dimension).
c)
10. Cut off non-yoke end of outer
driveline as follows:
d)
Measure from end of outer shield
to scribed mark (“Y” dimension)
and record.
e)
Cutter off outer shield at the
mark.
SHORTEN DRIVELINE LENGTH
Refer to Figure 1-14:
7.
If dimension “A” is less than 1”, shorten
driveline as follows:
a.
Measure 1"
(“B1” dimension) back from outer driveline shield and make a mark
at this location on the inner driveline shield.
b.
Measure 1" (“B2” dimension) back from the inner driveline shield and make a
mark at this location on the outer driveline shield.
8.
Remove outer driveline from the tractor power take-off shaft and inner driveline from the
implement’s gearbox shaft.
9.
Cut off non-yoke end of inner driveline as follows:
Summary of Contents for 191587
Page 41: ...41 STANDARD SERIES ROTARY CUTTER PARTS LIST...
Page 42: ...42 STANDARD SERIES ROTARY CUTTER PARTS LIST...
Page 43: ...43...
