Tungsten Stick Out – 5/8” – 3/4”
Tungsten to Wire = 3/32”
Tungsten to Wire = 3/32”
Tungsten Stick Out = 5/8”- 3/4”
1. Remove all liner consumables so the torch is bare.
2.
Make sure the correct drive rolls are installed.
3.
Set the wire feed speed to 100.
4.
Use a file to round off wire before inserting in into the TIP TIG.
5.
Run the wire until it is about 12 inches past the handle.
6.
Install liner and guide blocks…Make all settings as shown below.
7.
Orientate the guide block to the desired position.
8.
Run 15 inches of wire to ensure the wire cast has been straightened.
9.
Set tensioners to around 3 and you are ready to weld.
Load Welding Wire on the TIP TIG
Loading the Wire
19
Summary of Contents for Hot Wire Unit
