TIP 30310, Translation Of Original Operating Instructions

Page: 22 / 52

8
9. Maintenance and care
Prior to carrying out any maintenance work, the pump must be separated from the electrical
mains. If you fail to separate the unit from mains, there is a risk of an inadvertent start of the
pump.
We decline any liability for damage caused by inappropriate repair attempts. Any damage
caused by inappropriate repair attempts will avoid all warranty claims.
Observing the conditions of use and the ranges of application of the present device will reduce the risk of possible
operational malfunction and contribute to extend the lifetime of your unit. Sand and other abrasive matters con-
tained in the liquid discharged will speed up the process of wearing and tearing and accelerate the drop in per-
formance.
The user must ensure that maintenance is done from
qualified persons , who have carefully read all instructions
for installation and maintenance.
In case the set is not used for a longer period, the pump and filter tank must be drained. Frozen water inside the
pump and filter tank can cause severe damage. Store the pump at a dry and frost-proof location. If the pump is
operated again after a longer break, please ensure all sealing and und O-Rings are in good condition. Replace
any defect or damaged sealing’s.
Check, if the motor shaft is moving freely before each new operation.
Check and clean the tube with filter basket (fig. 8, No. 5) in the sand filter tank (fig. 8, No. 4) in regular intervals .
1. Remove the lid with 4 position valve (fig. 8, No. 1) and take out the tube with filter basket (fig. 8, No. 5).
2. Clean the filter basket with clear water.
3. Do the assembly in reverse order. Check the sealing of the lid (fig. 8, No. 3). Replace damage
d sealing’s im-
mediately.
4. Insert the tube with the filter basked (fig. 8, No. 5).
5. Fill the sand filter tank again.
6. Place the o-ring correctly.
7. Pull the lid by hand.
8. Switch on the pump again.
A regular check of the mechanical and electric parts is recommended:
1. The accurate and right connection of adapters, hose and pipes and secured tightness of all screws.
2. The correct condition of all electric connections and power cords.
3. The vibration of the pump. In case of an excess high vibration, stop the pump immediately and contact your
service partner or the manufacturer.
10. Troubleshooting / tips
In the case of malfunction, you should first of all check whether it was caused by an operating error or some other
reason which cannot be attributed to a defect of the device - for instance a power failure.
The list below shows some possible malfunctions of the device, possible causes and tips on their elimination. All
the measures referred to may only be carried out with the pump being separated from the electrical mains. If you
yourself feel unable to eliminate any of these malfunctions, please contact the customer service department or
your point of sales. Any repair beyond the scope specified below must only be performed by qualified staff.
Please bear in mind that all warranty claims will become void in the case of damage caused by inappropriate re-
pair attempts, and that we decline any liability for any ensuing damage.
M
ALFUNCTION
P
OSSIBLE
C
AUSE
E
LIMINATION
1. The pump is not
discharging any
liquid, the motor is
not running.
1.
2.
3. No current.
Thermal motor protection feature has
triggered.
The capacitor is defective. 1.
2.
3. Please use a device complying with GS
(German technical supervisory authority)
to check for the presence of voltage (safe-
ty information to be observed!). Please
verify the correct position of the plug.
Separate the pump from the electrical
mains, allow the system to cool down,
eliminate cause.
Please contact the customer service de-
partment.
20