Timewave PK-232SC, Hardware Installation Manual

Page: 8 / 38

8
PK-232 Disassembly
Complete all disassembly steps before starting the new
assembly steps!
____ 1) Remove all cables and power from unit.
____ 2) Remove the six screws holding the top cover on the unit.
____ 3) Remove the top cover.
____ 4) If you have a PK-232MBX with a daughter board,
temporarily remove the MBX board. Do not bend the pins
on the bottom of the MBX board.
____ 5) If a DSP board is installed, you may leave the DSP board
in place.
____ 5B) If you have a OVL LED assembly installed, unplug the
IDC connector from the header next to the red LED on the
DSP board.
____ 6) Remove the threshold control knob from the front panel.
Carefully remove the nut and washer from the bushing of
the threshold control.
____ 7) If your unit has a panel-mounted power connector and/or
reset switch, carefully remove the nut and washer from the
bushing of each.
____ 8) Remove all the screws from the bottom of the PK-232
housing that hold the main board in place. There may be 6
or 7 screws, depending upon the model of the PK-232. Do
not remove the screws that hold the standoffs to the main
PC board.