10
plastic part of the connector, do not use excess heat when
soldering the connector.
Be very careful in the following steps if you do not
have experience de-soldering multi-pin
connectors from PC boards!
____ 17) If the DB-25 25-pin connector on the left rear corner of
the PK-232 main PC board is installed, carefully de-solder
and remove it.
Do not burn the PC board with excess heat!
Do not damage the vias or traces on the PC board!
Use
care when removing this part so you do not burn the
board. The holes will not be used again so you can clip
those leads which may be accessible from the rear of the
connector on the top of the board. Note some connector
styles have no exposed leads.
____ 18) Clean all excess solder from the vias for the DB-25
connector.
Do not burn the PC board with excess heat! Do
not damage the vias or traces on the PC board!
____ 19) If you have a Timewave USB adapter module installed
in place of the 25 pin DB RS-232 connector, remove the
USB module.
Do not burn the PC board with excess heat!
Do not damage the vias or traces on the PC board!
Summary of Contents for PK-232SC
