7
8
HELPLINE
020 8450 0515
Masking the Sensor Lens
• To restrict the sensor coverage, preventing detection in unwanted areas, mask
the sensor lens using the masks provided in the accessory pack (see diagram H).
• The top section of the lens covers long range detection, the bottom covers short
range. Similarly the left and right lens sections cover the left and right detection
areas respectively.
Manual Override Mode – Single LED Illuminated
The light can be switched on for longer time periods by use of the Manual
Override Mode. This can be activated at night by using the internal wall switch
or circuit breaker.
• Switch the internal wall switch/circuit breaker twice (OFF/ON, OFF/ON)
within 2 seconds.
• The unit will now illuminate continuously for the user defined time,
between 1 – 8 hours, or until the unit is switched back into auto mode.
• The ON time can be set by rotating the centre adjustment knob as required
(see diagram G). This time adjustment is factory set to 1 hour
(Fully anti-clockwise is 1 hour, fully clockwise is 8 hours).
Note: If the light is still ON at dawn, before the set time expires, it will
automatically switch OFF.
• The Manual Override Mode can be setup in the day time or at night time.
• In the day time, the Manual Override mode is indicated by the permanent
illumination of a single red LED in the top of the sensor head.
• At night time, no red LED will be visible.
• To switch the unit back into Auto Mode, flick the internal wall switch/circuit
breaker (OFF/ON) once within 1 second. The unit will return to Auto Mode.
This is indicated by the return of the left to right scrolling LED’s as described
in Automatic Operation above.
Holiday Mode – Single LED Flashing
The benefit of Holiday Mode is that the user can program the unit automatically
illuminate for a certain time, (1 – 8 hours) each night. At dusk the unit will
illuminate for this set period after which it will extinguish. The unit will continue
to operate normally when it senses movement until dawn. At dusk the following
