Full Technical specification available upon request. Contact [email protected] for PDF.
Instructions for new installations:
ALWAYS SWITCH OFF THE MAINS SUPPLY BEFORE
INSTALLATION OR SERVICING.
• Install the unit according to wiring diagram. Deviation
from the advised setup may lead to permanent damage to
the unit.
• Once wiring is complete, ensure the lid is fixed in place
using the screw on the base.
• Once installed, the indicator LED will be illuminated.
• To ensure maximum performance of the built-in battery,
please fully charge the unit for 36 hours after first
installation.
• To extend battery life, conduct a discharge test of the
battery at least once every three months.
Secure LED Emergency Driver
Cleaning:
• Do not use any chemical or abrasive cleaners.
• Clean product with only a soft dry cloth.
Warranty:
• This product is warranted to be free of defects in materials, design and workmanship for 3 years from the date of
purchase (conditions apply, please see TIME LED website for further details). If a suspected fault should develop in this
time, please contact us via the address on the front.
Recycling Advice:
Waste Electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice.
Product Code
781005
Size (mm)
170x33x55
Lifespan (Hours)
25000 hours
IP Rating
IP20
Input Frequency
50Hz
Input Current
1A MAX
Fuse
250V 1A
Voltage
110-265V 50/60Hz
Class
Class II
Material
Mixed Polycarbonate
Lamps
3-100W Lamps Only
Emergency Battery
Nimh 4.8V 2.5Ah
Emergency Charge
Time (Hours)
36 hours
Emergency
Discharge Time
(Hours)
3 hours
Emergency
Output Voltage
5-42V
Warranty
3 Years
Product Weight:
240g
Ta: 50°C Tc: 75°C
LED Indicator Functions:
• LED green on: mains ok and battery connected
• LED green slow flash: low battery
• LED green rapid flash: poor connection between emergency
pack and LED Lamp
• LED off: ‘Emergency pack is operating for LED lamps
currently experiencing a power cut’ or ‘Battery is out of power.’
CLASS II WIRING DETAILS (FIG.1)
• Primary 240V 50Hz
• Class II
• Wire-Brown cable to connection marked ‘L’
• Wire-Blue cable to connection marked ‘N’
Wiring Diagram (FIG 1)
