Timberk SWH MS210H, Instruction Manual

Page: 3 / 32

3. Connect the water heater only to 230V, 50Hz main. If necessary, find
out parameters of your mains at power suppliers.
4. To prevent overheating and risk of fire, as well as damage of internal
electrical main, do no modify the power cord's length and do no
connect the water heater through electrical extenders.
5. It is forbidden to switch on the water heater if it is not filled with water
or if water cannot go through a pressure safety valve.
6. Never use the water heater if it is broken.
7. Do not remove the water heater cover when it is in operation.
8. Immediately unplug the water heater from electrical main if strange
sounds, odor or smoke are coming from it.
9. Always unplug the water heater from electrical main during a
thunderstorm.
10. Prior to cleaning and maintenance of the water heater unplug it from
electrical main. Cleaning and maintenance must be performed in
compliance with instructions of this operation manual.
11. Do not use hazardous chemical substances to clean the water heater
and prevent their contact with the appliance.
12. To prevent electrical shock the damaged power cord must be
replaced only in manufacturer's authorized service centers by qualified
specialists.
13. To prevent electrical shock do not place the power cord nearby
heating devices and flammables or combustibles.
14. Do not press buttons on the control panel of the water heater and its
remote controller (for some models) otherwise but by your fingers.
15. Since temperature of water in the water heater can reach 75°C, when
it is in operation you should not place your body parts under hot water
at the first run.
To prevent burns you should adjust the temperature of the discharging
water.
16. Do not use the water heater for purposes not specified by this
operation manual.
17. Do not use the water heater in an explosive or corrosive
environment. Do not store gas and other volatile flammable liquids next
to the appliance it is very dangerous!
18. It is forbidden to make alterations in the design of the water heater
or modify it.
19. Any service operations must be performed by a specialized
organisation and qualified specialists. Improper installation may cause
voiding of guarantee maintenance.
20. The water heater is not intended for use by children and persons
with reduced physical, sensory or mental capabilities, or a lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by an individual responsible
for their safety. Children should be supervised to ensure that they do not
play with the appliance.
3. PERFORMANCE PARAMETERS
1. Completely automatic control: automatic water heating, continuous
automatic water temperature control.
2. 3D Logic® three-stage protection system:
DROP Defense leakage protection and protection against surplus
pressure within a tank (pressure safety valve)
SHOCK Defense current leakage protection (GFCI is built in the plug
of appliance's power cord)
HOT Defense two-stage overheating protection (thermostat and
temperature limiter)
ALL PROTECTION SYSTEMS ARE RELIABLE AND SAFE.
3. Pipes of heating elements are designed taking into account high heat
load: safe and reliable, with an increased service life.
4. NON CFC urethane foam insulation of increased thickness: excellent
heat insulation that allows to efficiently retain accumulated heat and
save energy.
5. Temperature controller: accurate and reliable water temperature
control.
6. Internal tanks and all internal components are made out of SUS 304
stainless steel with walls 1.2 mm thick.
7. Magnesium anode is for additional protection of the tank and seam
joints.
ENGLISH
3
www.timberk. storage water heater com electrical