5
Radio Control
Group Addition or Removal
Before you begin, operate the window shading
using infrared control to make sure that you are
communicating with only one window shading and
that the window shading is working properly.
TIP:
Move the remote as close as possible (2"– 3") to the sensor
eye when assigning groups.
1. With a
paperclip,
press and
release the
recessed
SETUP
button on
the back
of the
remote. The
Indicator Light on the front of the remote flashes green for
approximately 30 seconds.
2. While the Indicator Light is flashing green, press the group
button for the group to which you plan to assign the window
shading.
3. Point the
remote at the
sensor eye of
the window
shading and
press the
OPEN
button to add
the window
shading to the group or the CLOSE button to remove the
window shading from the group. The window shading moves
slightly (or “jogs”) to indicate that it has been added to or
removed from the group.
4. Exit setup mode by pressing and releasing the SETUP button
a second time. The remote saves any changes made and the
Indicator Light stops flashing.
1
2
1
4
3