6
- Parameter N-9-6-17 (1500 RPM*) Speed of exhaust gasses fan in period between detecting stabile
fire and working mode
* RPM stands for : Round Per Minute
In this phase it is important to follow up the way of burning in the burning pot. In case of high
speed or low speed of exhaust fan, parameters should be tuned and corrected (depending on air flow
and draft of chimney). Check the look of flame, if the flame is “dancing” and wood pellet is
“bouncing” in the burning pot, fan speed should be reduced.
“Dancing fire” and “bouncing pellet” / Stabile and established fire
WORKING MODE
After entering working mode, Installer is obliged to monitor and to follow up the way stove is
working in Mode 5 and Mode 1 (maximum and minimum).
Stove is set to maximal power 14 kw (4 kW given to room, i 10 kW given to water), until in MODE
1, WORK MODULATION (on minimum) Power is set to 6kW (2,2 kW given to room and 3,5 kW
given to water). Thermal output is influenced by quality of pellet.
Having in mind that one working cycle of stove is determined with parameter N-9-6-3 (15 minutes)
and that cleaning is determined with parameter N-9-6-12 (30 second).
WARNING:
Installer is obliged to follow up at least 3 working cycles including cleaning of burning pot
(both minimal and maximal values).
REMARK:
Parameters which are influencing cleaning of burning pot are:
- N-9-6-3 Time duration of burning pot cleaning. Every 15 minutes, exhaust gasses fan blowing is
increasing in order to clean burning pot.
- N-9-6-12 Time interval of burning pot cleaning (45 seconds)
- N-9-6-29 Fan speed during cleaning of burning pot (2100 RPM)
- N-9-6-30 Loading pellet during cleaning of burning pot (0,5 second)
In this phase it is important to follow up the way of burning fuel in the burning pot in order to
prevent high speed of exhaust fan which result with “bouncing pellet”
