4
ADJUSTING THE PELLET STOVE
Process of setting parameters is having 2 (two) phases:
1. Following and setting of starting fire (kindling), and establishing of stabile fire
2. Following and setting of working mode
Pellet stove is produced with basic settings included and those setting should be suitable
for majority of real situations which installer could meet in most of cases‚ but it is apsolutely
necessary to check pellet stove work (in several cycles of burning and cleaning burning pot).
REMARK: Check if option “
WINTER SEASON
” is turned ON
(There is instruction in OWNERS MANUAL how to turn it ON).
ENTERING THE MENU FOR SETTING PARAMETERS
To enter Menu for setting parameter you should do the following:
- Press the button SET (3) after which display will show MENU 01 SET CLOCK - Then use the
buttons (5) or (6) in order to reach 9.
Display will show MENU 09 SETTINGS TECHNIC
- Press the button SET (3). Display will show MENU 09 KEY ACCESS, which mean you should
enter the PASSWORD for entering parameters.
In upper left corner of the screen you will find symbol 00 .Press the button (1) to get to symbol
A9 (1,2,3,......98,99,A1,A2,...A9)
A9 is PASSWORD to enter PARAMETER SETTINGS
- Push the button SET (3), to enter parameter settings. Display will show N-9-1 TYPE PELLET.
- To exit parameters, push the button ON/OFF shortly for several times (4)
PHASE OF IGNITING/LIGHTING THE STOVE (LOAD PELLET)
In this phase it is necessary to control loading of burning pot with pellet and to check
quantity of pellet after initial loading which last 30 seconds. This period of time (30 sec.), is defined
with parameter N-9-4-03
In lighting/igniting phase, pile of pellet is filling 1/3 of burning pot (approximately, almost
closing the hole in burning pot which is made for Lighter/Igniter. Parameters which are influencing
igniting/lightning are:
- Parameter N 9-4-03 (30 seconds) initial loading of burning pot
- Parameter N 9-6-16 (1400 RPM.) Fan speed in lighting/igniting phase
- Parameter N 9-6-04 (0, 8’’) Time of loading pellet in lighting/igniting mode
* RPM stands for: Round per Minute
REMARK: working Auger pause = Auger cycle of 8 seconds ( If auger working
period is 0,8 seconds, than 7,2 seconds is period of auger pause.)
