TIGMON LAUBEN 200ST, Manual

Page: 8 / 28

8 |
The guarantee does not apply to any damage caused by non-standard usage, mechanical damage, exposure to severe conditions or
by handling it in contradiction to the manual recommendations, as well as damage caused by ordinary wear and tear.
■
Neither the manufacturer, importer nor the distributor take responsibility for any damage caused by the assembly or incorrect usage
of the product.
IMPORTANT SAFETY INSTRUCTIONS
■
The appliance is designed for grinding coffee beans, nuts without shells, herbs, poppy seeds and certain types of spices. Do not use it
to grind excessively hard foodstuffs such as nutmeg, etc. or use it for purposes for which it is not intended.
■
Do not wash the appliance (except for the lid) under running water and do not submerge it in water or any other liquid.
■
The appliance is equipped with a safety mechanism that prevents it from being started when the lid is not properly attached.
■
Do not use the appliance when empty, otherwise its service lifetime could be negatively impacted.
■
The maximum continuous operating time of the appliance is 1 minute. After approximately
1 minute of operation
, allow it to cool
down for approximately
2 minutes
.
■
Always turn off the appliance and disconnect it from the power supply, if you will not be using it, if you are leaving it unsupervised,
before filling or emptying the grinding bowl, before mounting or removing the lid and before cleaning. Do not remove the lid from
the grinding bowl while the grinding blade is moving. Always wait until the blade comes to a completely standstill.
Attention:
Improper use can lead to injury!
■
Be especially careful when emptying the grinding bowl and when cleaning to prevent injury from the grinding blade.
■
Do not disconnect the appliance from the power supply by pulling on the power cord. This could damage the power cord or the power
socket. Disconnect the cord from the power supply by gently pulling on the plug of the power cord.
PRODUCT LAYOUT
Product may vary slightly from illustrations.
1. Lid
2. Blade
3. Micro-switch
4. Grinding bowl
5. Unit base
6. Socket
7. Removeable power cord
1
3
5
6
2
4
7
DE
EN
CZ
SK
PL
HU