Tiger TWT-01, User Manual

Page: 6 / 6

7
8. G value
In the weighing model, press and hold
【
tare
】
key, and then press
【
print
】
key
，
it shows
UF-1. Press
【
tare
】
key for eight times
，
it shows UF-9. Press
【
print
】
key
，
it shows
-00-
，
and then shows 9.79423
（
G value of the manufacturing place
）
. And then press
【
print
】
key to adjust the G value of the using place, the first number in the left
begins to twinkle, and press
【
net/gross
】
key to choose the number. Press
【
ZERO
】
key to move cursor to left or press
【
tare
】
key to move cursor to right. Press
【
print
】
key to confirm, and press
【
units
】
key to back to weighing model.
Calibration:
1. Weight and zero calibration
In the weighing model, press and hold
【
print
】
key, and then press
【
ZERO
】
key,
it shows ECF-1. Press
【
print
】
key, it shows CAL Z to begin zero calibration. Press
【
print
】
key, it shows the weight which was calibrated last time. Use numeric key to
change the weight, and then put the required weight on the plate. And then press
【
print
】
key to finish calibration.
2. Zero calibration
In the weighing model, press and hold
【
print
】
key, and then press
【
ZERO
】
key,
it shows ECF-1. And then press
【
net/gross
】
key, it shows ECF-2. Press
【
print
】
key,
it shows CAL Z. Press
【
print
】
key to calibrate zero and back to weighing model.
3. Weight calibration
In the weighing model, press and hold
【
print
】
key, and then press
【
ZERO
】
key,
it shows ECF-1. And then press
【
net/gross
】
key twice, it shows ECF-3. Press
【
print
】
key, it shows the weight which was calibrated last time in the Weighing Window. Use
numeric key to change the weight, and then put the required weight on the plate. And
then press
【
print
】
key to finish calibration.
Error Messages
Err H Initial zero too high (over 10% of max. cap.)
Err L Initial zero too low (less than 10% of max. cap.)
Err N Unstable internal value
hhhhhh Overload, over the max. ca 9d
------ Total price exceeded 999999
Remark
0 0 0
A B C
A: Buzzer on: 0= Stable not required 1= Stable required
B: LCD indicator and RELAY on: 0= Stable not required 1= Stable required
C: Buzzer beeps when: 0= Buzzer off 1= OK 2= LO and HI