Tiger PDU-A30W, User Manual

Page: 9 / 68

Be sure to clean the unit before use.
There may be a smell of plastic when
first used. This is normal and will
diminish with use. 1. Add water to max water level and then bring up to boil. (See below)
2. After water is boiled, use electric dispenser button to discard half of hot
water. (See
p. 10
)
3. Unplug the power cord, open the lid and then discard the rest of hot
water. (See
p. 16
)
English
8
1
Open the lid.
Push
Open
You may hear rattle sound when
opening /closing the lid. There is a
valve in the outer lid for prevention
of water spillage.
2
Pour water into the unit
with a separate container.
Fill water to level between "Max water level" and "Refill
water mark".
MAX
M A
X
Do not splash water
onto the operation
panel.
Refill water
mark
The highest level to which
water can be poured
Max water level
Pour slowly.
• Do not fill water directly from a faucet.
Do not place the unit on wet surface.
• Automatic Boil cycle may not work
when refilling hot water above 50°C,
be sure to add lukewarm water or cold
water or press
Re-Boil/Timer
key.
(See p. 9 )
• Do not exceed "Max water level". Do
not boil water if the water level is lower
than refill mark.
Caution
3
Boiling Water
3
Close the lid.
Click
Hold both side of lid
and close it securely
If the lid is not closed securely, hot water
may spill and cause scaling.
Caution
4
Connect the power cord.
Receptacle
Plug in
Plug in
Appliance
plug
Outlet
Plug
Beeping
sound
5
Boiling starts.
Light
illuminates
Flashing
※
Refer to
p. 9
when selecting the temperature for
Warmer. ( If no selection is made, a temperature of
90°C will be automatically set. )
※ Refer to
p. 12
for setting the power-saving timer.
■
Eliminate chlorine smell
Press Re-Boil/Timer key once.
※ extend boiling time
Flashing
Beeping
sound
Flashing
Before first use / When not used for a while