Tiger JD 5083E, Mounting And Operating Instructions

Page: 81 / 182

Cheetah Maintenance Section 4-3
MAINTENANCE
REGULAR MAINTENANCE
The intervals at which regular servicing should be done are based on hours of
operation. Use the tractors hour meter to determine when regular servicing is
required.
This symbol indicates a point that needs to be greased at an interval
noted in the section below. Refer to the Detailed Maintenance section
for further instructions on greasing. Copy and use the Daily
Maintenance sheet located at the end of this section.
DAILY OR EVERY 8 HOURS
ITEM SERVICE COMMENTS
Pump Drive Shaft Check and Lube Insure drive shaft end
play
Crankshaft Adapter Check rubber grommets Replace grommets if
damaged or missing
Pivot Points Lubricate Inject grease until it
appears at ends
Hydraulic Fittings Check for leaks Tighten when needed.
Do Not use hands to
check for leaks, see
maint. Precautions
Knives Check Inspect for missing or
damaged knives, change
as needed
Knife mounting bolts Check Re - torque to 800 ft. lbs.
(knife to disk)
Disk mounting bolts
Check Torque to 180 ft lb lubricated
(disk to spindle) Torque to 204 ft lb dry
Spindle mounting bolts Check Torque to 315 Ft lubricated
(Spindle to Deck) Torque to 357 Ft dry
Belts Check / Adjust Check if broken, tighten
as required
Main Frame and Check Retorque bolts to torque
Deck specifications in this section
Hydraulic Fluid Level Check Add if required per
fluid recommendations
Rear Flail Drive (if applicable) Lubricate Grease as instructed in
Bearing Flange and detailed maint. section
Shaft Coupler
Cutter Shaft and
Lubricate Grease as instructed in
Ground Roller detailed maint. section
Ground Roller Bearings Lubricate Grease as instructed in
detailed maint. section
Cutter Shaft Bearings (Flail) Lubricate Grease as instructed in
detailed maint. section