Edition
Manual
Chapter
Page
2008-10-17 Workshop Manual, Stiga Titan 6 Control wires
5
6.2.3 Inspections
• Check that the wire can be easily moved in its
conduit during the entire stroke.
• Check that the conduit is free from sharp
bends and other damages. The conduit outer
cover must be intact to prevent water to enter
the wire.
• Check that the conduit end sealings are
intact.
6.2.4 Assembly
1. Lubricate the wire through its end sealings.
Use machine oil. Slide the wire between its
end positions until the oil has reached the
entire wire.
2. Fit the wire to the machine as observed dur-
ing the disassembly. See also the figure.
3. Adjust the wire. See below.
6.2.5 Adjustment
It is important that the drive wire is correct
adjusted, otherwise the max backward/forward
positions can not be reached and the wire is
exposed for excessive stress.
Adjust the wire as follows:
1. Remove the right and top motor hoods.
2. Block the drive pedal in its max speed for-
ward position. Use a piece of wood or simi-
lar.
3. Try to move the pump lever further inwards.
It shall not be possible. If it is possible,
adjust the wire conduit until the play is zero.
