Edition
Manual
Chapter
Page
2008-10-17 Workshop Manual, Stiga Titan 6 Control wires
3
To apart a elbow link
1. Fold up the circlip (4) from the elbow link
body.
2. Pull out the circlip.
3. Pry off the link body from the stud sphere by
help of a screwdriver or similar.
4. The assembly is performed in the reverse
order. The link body is pressed onto the
sphere by help of a polygrip or similar.
Note!
It is important that the circlip (4) is
inserted in both holes in the elbow link
body, otherwise the link will separate
during operation.
Adjustment
1. Loosen the nut (3) with a 8 mm wrench.
2. Apart the elbow link as described above.
3. Screw the link body in the desired direction
on the wire stud. If neseccary, move the nut
(3) on the stud.
4. Check the adjustment result by pressing on
the elbow link onto the sphere and without
assembling the circlip.
5. After adjustment, assemble in the reverse
order and tighten the nut (3) against the
elbow link body.
Note!
It is important that the circlip (4) is
inserted in both holes in the elbow link
body, otherwise the link will separate
during operation.
4
1
2
3
4
