Configuring the TDR60
01-0868-401B 12/02
43
Step 3:
The front panel menus used to change the required parameters are:
Step 4:
To configure the TDR60 for this example, you first initialize the unit to
DVB default settings.
Step 5:
Once the TDR60 is set to the DVB default settings, all other required
parameters can be set.
If using the front panel, perform the following steps:
1. Select Input> Config. The RF Freq is displayed. Using the numeric keypad,
type the RF frequency,
11774
and press Enter.
2. Press Next to advance to the LO Freq parameter.
3. Using the numeric keypad, type the LO frequency, 10750, and press Enter.
4. Press Next and advance to the Code Rate parameter.
5. Scroll through the list of code rates and select the required parameter,
3/4
.
6. Press Enter to set the code rate.
7. Press Next to advance to the LNB Power parameter.
8. Scroll through the list of LNB power parameters and select the required
parameter,
13V
.
9. Press Enter to set the LNB power.
The demodulator is configured.
10. Set the date and time
11. Select the service, if required.
Step 6:
Save the configuration.
Step 7:
Ensure that the decoder is correctly configured to operate with the
encoder. As part of this process verify that the parameters you just entered are
correct.
SCPC Selection
For SCPC signals, the TDR60 automatically selects the available service. View
the selected services using the front panel Service menu or the remote DC PROG
command. The TDR60 displays the current service.
If the TDR60 displays
No Services Available
, verify that the Status LED is
illuminated. If the Status LED is not illuminated, refer to the chapter on
troubleshooting procedures.
Parameter
Front Panel Menu
Remote Command
RF Freq
Input>Config>RF Freq = 11774
QD
RF
11774
LO Freq
Input>Config>LO Freq = 10750
QD
LO
10750
Code Rate
Input>Config>Code Rate = 3/4
QD
CR
3/4
LNB Power
Input>Config>LNB Power= 13V
QD
LNB
13V
