Tidland Class I, User Manual

Page: 3 / 58

KNIFEHOLDER SAFETY
www.maxcessintl.com Tidland Performance Series Manual Knifeholder MI 557416 1 Q Page 3
IMPORTANT !
When using knifeholders, basic safety precautions should always be followed to reduce the risk of
personal injury. Your company's safety instructions and procedures should always be followed. When
using this product with any other equipment or machinery, all safety requirements stipulated by that
equipment or machinery manufacturer must be followed. Compliance with local, state, and federal
safety requirements is your responsibility. No part of these or the following instructions should be
construed as conflicting with or nullifying the instructions from other sources. Be familiar with the
hazards and safety requirements in your work environment and always work safely.

The
knifeholder’s intended use is to produce a slit with a driven anvil system. There is no other
intended purpose.

Read and understand all instructions before operating the knifeholder. Failure to follow instructions
may cause the knifeholder to function incorrectly and can cause serious injury.

The knifeholder contains spring-loaded components. While operating the knifeholder, follow all
existing plant safety instructions and/or requirements.

Always wear stainless steel protective gloves when changing or removing the knife blade.

Sharp knives can cause serious injury. Do not put hands in machines. Compliance with federal,
state, and local safety regulations is your responsibility. Be familiar with them and always work
safely.

Inspect the knifeholder cartridge for wear and/or other safety and functional deficiencies daily,
before each use.

Do not carry or lift this product over wet or slippery surfaces.

All replacement parts used on this product should be made to original Tidland specifications.

All maintenance and repair procedures performed on this product should be done to Tidland
specifications by qualified personnel.
RECEIVING AND UNPACKING

Handle and unpack the equipment carefully. Upon arrival, check the shipment against the
packing list.

Promptly report to the carrier any damaged equipment.

Equipment not installed immediately should be stored in a clean, dry location.

Be careful to prevent moisture, dust, and dirt from accumulating in storage and installation areas.
CAUTION
Wear eye protection when using tools or compressed air.
HAND HAZARD.
Keep clear. Keep
hands away from knife
blades at
all times.