3-6
TR/YR Owners Manual
OM_TR_0712RevC
CHAPTER 3: FOOTRESTS
Adjusting the Angle
Tools needed:
• 3/16” Allen Wrench
1. Loosen, but do not remove, the two Allen screws that
secure the stop clamps to the footrest extension tube.
See Figure 3-12.
2. Adjust the footrest to the desired angle.
3. Tighten the Allen screws. Make sure the screws are
secure and will not permit the footplate to rotate up or
down under weight.
Adjusting the Height/Replacing
You can adjust the height of, or replace, the flip back
footrest by using the tools and following the procedures for
adjusting the height of, or replacing a footrest as set forth
under “Titanium Footrest with Flat ABS Cover - Adjusting
the Height/Replacing (TR and YR Series 2)” on page
3-2 or “Angle Adjustable Footrest - Adjusting the Height/
Replacing (TR Series 3)” on page 3-4.
Buckle Adjustable Calf Straps
Buckle Adjustable Calf Straps are shown in Figure 3-13.
Install the calf strap as shown in Figure 3-13.
Adjustable Calf Strap/Padded Adjustable
Calf Strap
The Adjustable Calf Strap and Padded Adjustable Calf
Straps are shown in Figure 3-14. Install the calf straps as
shown in Figure 3-14.
Figure 3-13
Buckle Adjustable Calf Strap
Figure 3-14
Padded Adjustable Calf Strap
Figure 3-12
Adjusting the Angle
Footplate
Footrest
Extension Tube
Stop
Clamp
Allen
Screws