4-7
TR/YR Owners Manual
OM_TR_0712RevC
CHAPTER 4: BACKRESTS AND PUSH HANDLES
4. If your backrest is set to 9” or 9-½” and if you are setting the backrest at 8-½”:
a. Remove the backrest from the backrest brackets. See “Replacing the Backrest (TR and YR Series
2)” on page 4-9.
b. Remove the backrest posts from the backrest. See Figure 4-9.
c. Remove the backrest sleeves from the backrest. See Figure 4-9.
d. Insert the top end caps in the backrest. See Figure 4-9.
e. If the backrest is titanium, remove the short end plugs (see Figure 4-9) and install the long end plugs
in the bottom ends of the backrest.
f. Secure the backrest to the brackets using the Allen screws. See Figure 4-12. See “Replacing the
Backrest (TR and YR Series 2)” on page 4-9. Proceed to Step 7.
Figure 4-12
Adjusting the Backrest Height
Second
Lowest Hole
Backrest
Allen Screw
Locknut
Bracket
5. If your backrest is set to 9” and if you are setting the backrest at 9-½” or if your backrest is set to 9-½” and if you
are setting the backrest to 9”:
a. Remove the backrest from the backrest bracket. See “Replacing the Backrest (TR and YR Series 2)”
on page 4-9.
b. Reposition the backrest posts inside the backrest so that the desired hole in the backrest post aligns
with the second lowest hole in the backrest and with the bracket. See figure 4-13.
c. Secure the backrest posts inside the backrest and the backrest to the bracket using the Allen screws
and locknuts. Note that the Allen screws used to secure the backrest posts inside the backrest will
also secure the backrest to the brackets. See Figure 4-10. See “Replacing the Backrest (TR and YR
Series 2)” on page 4-9. Proceed to Step 7.
6. If your backrest is set to 9” or 9-½” and if you are setting it to 10” to 12-½”:
a. Remove the backrest from the backrest brackets. See “Replacing the Backrest (TR and YR Series
2)” on page 4-9.
b. Remove the backrest posts from the backrest. See Figure 4-9.
c. Install the threaded cane plugs in the bottom end of the backrest posts (see Figure 4-9) and reinstall
the backrest posts in the backrest tubes.
d. If the backrest is titanium, remove the short end plugs (see Figure 4-9) and install the long end plugs
in the bottom of the backrest tubes.
e. Align the backrest canes inside the backrest tubes so that the desired holes in the backrest canes
align with one of the top three holes in the backrest tubes. See Figure 4-11.
f. Secure the backrest posts inside the backrest using the Allen screws. See Figure 4-11.
g. Secure the backrest to the brackets. See “Replacing the Backrest (TR and YR Series 2)” on page
4-9. Proceed to Step 7.
