ThyssenKrupp Mini gearless DAF270, Operating Manual

Page: 41 / 76

O
PERATING
M
ANUAL
5
.
P
UTTING
I
NTO
S
ERVICE
ThyssenKrupp Aufzugswerke GmbH
41
Issue 06.2004
5.1 Putting DAF 270 into service
Before you start putting the machine into service the following points are to
be checked and/or the following works performed:
•
Check mounting and aligning of machine, frame and rope departure
•
Check fastening of machine and frame
•
Tighten screws and secure with pre-set torque (see table tightening
torques in 8.1)
•
Check supply terminals, earthing of motor and brakes for connection and
test
•
Check thermal monitoring of motor and brake for connection to
connection PTC thermistor tripping device (not part of the supply
schedule)
•
Check brake and encoder for correct connection to control
•
Check lower release hole of drive for removal of plastic cover
•
Check whether safety, accessory and installations tools are removed
from the danger zone
•
Check armature base plate and brake connection (chapter 6.2 c)
•
Check brake control switches for proper connection and functioning
(chapter 7.3)
•
Perform brake test with one acting brake shoe each (chapter 6.2)
•
Check brake release (for emergency rescue even in case of power
failure) for proper functioning (not part of supply schedule)
•
Check rope guard cover or rope support for proper mounting and
distance (max. 2mm) (not part of the supply schedule of machine frame)
•
Check special mountings (optional) for correct mounting and functioning
Attention: if the drive is operated by a brake control circuit instead of an
emergency braking system (safety gear) against overspeed in upwards
direction, it must be observed that the elevator installation shall only be put
into service
with the brake monitoring faultlessly functioning !
Never put the installation into service without brake test switches by
disconnecting the check-back or brake test switches and resetting the non-
volatile memory (EPROM).
Disregard may cause danger to life of persons.