1.Carefully remove your Outlaw stand kit from the
box. Includes two stands, 4 sticks and 8 doublers.
Assemble the stand as illustrated.
5.
Remove the radio box cover by loosening 5 nuts.
6.Install 4 dry cells or rechargeable battery in the
battery holder. Change to 3600mAh 4.8V NiMH
battery pack is recommended. Insert the antenna
tube in the antenna mount.
7.Use balloon to well wrap the receiver and battery
holder, next seal the opening with the small
rubber band. This will help to resist from the
water or humidity.
8.Next install 8 dry cells in the Transmitter then open
the radio. Refer to the radio manual and page 10 to
adjust the throttle and rudder properly. Turn off the
radio switch after adjustment. Check all hardware
screws and make sure they are tightened before
starting the engine.
9.Remove the sleeve of water fin before starting the
engine or placing the boat in water. Always put the
sleeve on when boat is off water or use care when in
operation as it is sharp and may hurt your body.
11.Unplug the fuel line from carb then pump the fuel
to tank, 15% of Nitro is recommended. Of course
the higher percentage of Nitro, the more of the
power. However, high nitro means higher price
and also will decrease the life of engine.
7
6
OUTLAW 7.5
OUTLAW 7.5
2.You need to use epoxy or CA to secure the sticks
and doublers. Locate the foam tapes, then apply on
the top side of the front and the rear stand, this is to
protect the bottom surface of the hull.
3.Now you can place the Outlaw on the stand. Note
the orientation, if you place the Outlaw in a wrong
way then there will be a big gap between the bottom
surface and stand.
4.Open the hatch cover with your index finger at the
black fin. Always open the cover gently, do not open
wildly as this may damage two pins which are
located in the front of the hatch over.
10.The initial setting of the engine is suggested as
follows, a small flat head screw driver is required to
do the needle adjustment.
Main Needle 2-1/2~ 3 turn
Idle Needle 1-1/4~ 1-3/4 turn( Barrel Full Open)
Barrel open at 2~2.5mm as photo shown
2~2.5mm
