8
ASSEMBLY / LANDING GEAR
23. Install the rudder control horn. Make sure the
control horn is installed properly before you
press in the locking plate and do not over press
the locking plate.
24. Snap on the rudder pushrod.
25. Carefully cut the slots at the bottom fuselage
about 10mm(3/8") in depth.
26. Inser t the landing gear in the landing gear
mount then press the retainer all the way in to
secure the landing gear in place. When pressing
make sure to suppor t from the inside of
fuselage.
27. Trim the wheel pant as shown and drill 4mm
holes for wheel axle.
28. Install the wheel pant retainer then the landing
gear fairing. Insert the fairing root into the slot
you cut in the prior step. The fairing is for scale
look it may effect the performance. For better
stability, you may trim the fairing narrower.
29. Install the wheel pant and wheel on landing gear
next thread the plastic nut. Make sure wheel
rotates freely.
30. Secure the wheel pant with two 2x5mm wood
screws as shown. Do the same procedure on
the other wheel.
