12
STARTING THE ENGINE
發動引擎
14
a.
Turn on the radio (transmitter first, then receiver).
b.
Clip the glow plug igniter onto engine's glow plug.
c.
Pull on the engine starter, release, repeat until the engine starts. Throttle maybe required to be opened momentarily, but
release back to neutral immediately after it starts.
Remove the glow plug igniter from engine after engine has started and warmed up. If the engine stops right after the igniter is
removed, the carburetor setting is too rich. Please refer to engine setting section.
If engine starter becomes hard to pull, the engine maybe flooded. To unflood an engine, remove the glow plug from engine, flip the
car upside down, and pull on the starter to release excess fuel. Then, reinstall the glow plug and repeat the engine starting
procedure.
a.
打開遙控器電源(先打開發射機電源，再開接收機電源)。
b.
將電夾接上引擎的火星。
c.
拉動手拉器啟動引擎。油門微調可稍微提高一些，方便引擎的啟動。注意：手拉器拉出之長度必須保持在
20~35
公分之內，不可
超過
35
公分，避免將手拉器繩索拉出過長，造成損壞。
引擎發動達工作溫度後，將電夾移開。假如引擎立刻熄火，示引擎設定過於富油，請參考引擎設定單元，調整出最佳設定。
假如引擎很難拉動，甚至拉不動，示引擎已呈現積油狀態，請先將火星下，拉動手拉器數次，排油後裝回火星，重新啟動引擎。
a
b
c
Not pull on
over 35cm
STOPPING THE ENGINE
停止引擎
15
a.
Bring your truck to a complete stop and idle. Then, Remove the body clips and body.
b.
Using needle-nose pliers or a clothespin, pinch off the fuel line just before the carburetor until the engine stops (1-2 seconds).
DO NOT ATTEMPT TO STOP THE MOTOR BY TOUCHING OR GRABBING THE FLYWHEEL!
These motors have a lot of
torque and serious injury could occur from stopping the engine in this manner.
The exhaust gasses can be very hot, stopping the motor by plugging the exhaust with your finger could result in a serious burn.
c.
Turn off your truck and then the radio
a.
將車輛保持於靜止怠速狀態，將車殼移開。
b.
使用尖嘴鉗夾住油器前端油管夾住約1至2秒，直到引擎熄火。
注意：不可徒手強制停止飛輪運轉，避免造成傷害；不可用手指塞住排氣管，達到停止引擎的目的
，因為排氣管工作溫度與排出
之廢氣溫度皆相當高，將會造成相當大的傷害。
c.
將接收機與發射機電源依序關閉。
a
b
c
b
c
Summary of Contents for EB-4 S2.5 6242-F
Page 17: ...16 SET UP 22...
Page 20: ...19 REAR ASSEMBLY PD08 0017 PD1924 PD1981 W PD1924 PD1981 W PD1244 PD0560 T 1...
Page 31: ...JD8524...
