8
Release the Velcro-secured thoracic section.
THORACIC SECTION RELEASE
Install the black remote control lever into the bottom of the
base block by inserting the cable into the narrow slot and tilt
the cable end of the lever into the slot until it snaps into place.
Note the milled finger recess for later removal of this lever
when folding up the table. Operating this lever will allow the
headpiece to lay flush with the table cushions.
Table Set-Up
8
REMOTE CONTROL LEVER ATTACHMENT
1. Swing the headpiece flexion/extension piston down toward the
off-centered slot in the headpiece base block.
2. Remove the piston pin from the headpiece base block and
raise the front end of the headpiece to allow the piston to engage
the off-centered slot. Note: Operating the remote control lever
will allow you to rotate the piston head to align with the off-
centered slot.
3. Attach the flexion/extension piston to the headpiece base block
by visually lining up the holes and re-inserting the piston pin.
PISTON ATTACHMENT