Thrane&Thrane SB5006, Operation Manual, Page: 14 / 38

12
6. The upload procedure to be followed is the same as for the VHF file upload. Browse
for the applicable CU file on your PC and click on Apply.
7. During the upload process the following is indicated in the CU display:
SQ
Vol
1W
Tx
Figure 4.6: CU Boot-Load indication.
8. After a few seconds (~20) the software is uploaded and the display will return to the
ES indication (when upload succeeded).
The CU software version is not displayed on any HTML service pages, but can be verified
via the following procedure:
1. Turn off the CU.
2. Hold down and while turning the CU on (pressing ).
3. The SW version is shown in the display (as long as is pressed).
Note: Remember to restore all physical data connections in the connection box after all
uploads have been successfully applied.
4.1.3 Channel Tables and private Channels
The pre-programmed channel regions in the radio - international, US, inland waters (BI) and
Canadian areas - may be enabled from the service tool user interface (see operation manual
for channel list). From factory only the channel mode for International and US is enabled.
If an extended set of channels is required for a specific region, this must be configured using
the Channel Tables menu from the index page.
0546