21
Choice of tracking and ID-receiver signals
The default connections are horizontal high (HH) to the ID-receiver and vertical low
(VL) to the signal detector. The signal detector can be connected to any LNB output
however (as long as it's not used by the ID-receiver). Another output than the default
can be used to increase the signal-to-noise ratio on a specific satellite.
If the output for the ID-receiver is changed, a corresponding NID-table must be
loaded. See section Satellite identification
Alignment of heading indicator
If the satellite TV antenna is aligned with the ship's bow direction in the CCW end-
stop, the heading indicator's offset is zero.
If the antenna is positioned otherwise, the offset can be entered in the service menu.
See section Service menu
Chapter 3: Installation
Alignment of heading indicator
PL
T
25 metres
25 metres
Shield/black shrink tube
M12 connector IP67
8x0.25mm
Binder male cable
No: 79 5066 xxx 08
2
M12 connector IP67
4x0.34mm
Binder male cable
No: 79 5401 xxx 04
2
Pinout
Pinout
a (+24V DC)
1 (R422-)
4 (T422-)
6 (T422+)
7 (R422+)
3 (GND com)
2 (GND 24V)
5 (NC)
Chassi
1
2
3
4
Chassi
Red
White
Yellow
Pink
Blue
Green
Brown
Grey
Shield
Brown, +24 V
NC
Blue, GND
NC
Shield
2
2
+
“ Cable CPU - ACU”
“ Cable power supply”
Pinout
1
2
3
4
5
6
7
8
Red
Brown
Pink
Yellow
Green
Blue
White
Grey
+24 V
GND 24V
T422+
T422-
GND
R422+
R422-
NC
2
3
4
1
Red
Brown (+)
Black
Blue (GND)
White
Front view
7
1
2
a
5
3
6
Grey
Yellow
Green
Brown
Pink
Blue
White
4
NOTE: View front side
