T1216W-C
MARINEW-P-I
1
11/12
PAGE 16 of 39
5.5.2 To Fit the Optional Door Stay
1. A door stay is available as an option for the
T1216W-C panel.
2. A single door stay may be fitted to the door/back
box assembly during the installation of the panel
enclosure described in section 5.2.1. Also refer
to Figure 9
– Door Stay Assembly.
3. Materials required
– 1 off T1200 Door Stay
Assembly kit [508.023.025].
4. Tools
– ratchet socket set with 8mm and 10mm
sockets.
5. Locate the four fixing studs used to secure the
stay. Two M6 studs are located on the frame
holding the display board. These are used to
secure the door mounting bracket. Two M5
studs are located on the inner return face of the
back box at the bottom towards the door hinge.
These are used to secure the door stay
enclosure mounting bracket.
6. Offer the door stay door mounting bracket up to
the studs on the display frame as shown in
Figure 9 and fit one M6 washer and Nyloc nut
[supplied] to each stud. The nuts should be tight
enough to prevent movement between slider
assembly and door.
7. Adjust the door opening angle and the
orientation of the door stay arm so that the
enclosure mounting bracket can be fitted to the
studs on the enclosure. Secure with the M5
nyloc nuts provided. Tighten the nuts sufficiently
[with an M5 socket] to prevent any movement
between the bracket and the box.
8. Check the operation of the door stay. The door
should open to approximately 110 -120 degrees
allowing the sliding nut to spring into the latched
position latching the door open. To close the
door, push the door stay arm up to release the
door stay sliding assembly nut.
Figure 9
– Door Stay Assembly
