29
T-Cube NanoTrak Autoalignment Controller
19)On the NanoTrak GUI, click the ‘Settings’ button to display the Settings panel.
20)Select the Input/Output tab- see Fig. 5.4
21)Make the following parameter settings, as shown in Fig. 5.4
Input Signal Source -
Select
PIN (TIA) Input
Voltage Range
- Select
10V
Range
Voltage Routing
- Select
SMA + Hub
22)If desired, click the ‘Persist Settings To Hardware’ box. These settings will then be
loaded on each power up cycle.
Fig. 5.4 NanoTrak Settings
23)Click ‘OK to save the settings.
