THOR Jayco NORTH POINT 2021, Owner'S Manual

Page: 68 / 209

66
Section 4: Vehicle Operation
Power Awnings (if so equipped)
Each power awning will have its own control switch, which is typically located on the com-
mand center switch panel located inside the entrance door. Pressing and holding the switch
will extend or retract the awning.
Carefree® Longitude Awnings (if so equipped)
Offer the following features:
 Scissor style arms that do not require vertical ground supports.
 Adjustable arms with ( 6 ) position pitch adjustment.
 Worm gear driver motor eliminating the need for travel locks.
 Single switch operation, 12V motorized awning.
Awnings must be closed (and locked if applicable) while the RV is in transit.
 The effects of wind and rain on an awning are unpredictable and can
cause severe damage to the awning and/or the recreation vehicle. If wind
or extended periods of rain are expected, retract the awning.
 It is recommended that if leaving the recreation vehicle unattended for a
length of time you should retract the awning to avoid unexpected weather
conditions.
Electric Patio Awning With Remote Control
In Motion Detector (if so equipped)
Some patio awnings are equipped with a motion detector. If the patio awning experiences
extreme or excessive movement, it will automatically retract to the travel mode position.
For detailed safety and operating information, refer to the manufacturer’s user guide.
Girard Awnings – refer to the manufacturer’s owner manual which is located on both a
CD and a USB flash drive included in your warranty packet. This CD (or flash drive) will
include several different awning manuals including slide out toppers and patio awnings.
Included also is troubleshooting, service and repair information. Follow all safety related
warnings and information included in the manuals.
NOTE: The electric awning requires connection to a 120-volt power
source. Make sure you have sufficient power available before operating
your awning (refer to Electrical Systems, Calculating electrical load). **Cer -
tain awnings (Reatta, Reatta XL & Embark) require a 12VDC power source.